AvL Technologies AAQ Antenna Controller User Manual

AvL Proprietary and Confidential
Content is Subject to Change without Notice Page 132 of 195
Most of AvL’s linearly polarized feeds include an automatic polarization adjustment feature, but not
all. All of AvL’s circularly polarized feeds employ a quick and easy Manual Pol change feature. When
this flag is set and the AAQ detects that it is being configured for a change in the polarization value,
the operator of the antenna will be prompted to perform a manual change of polarization by the
GUI. The AAQ will not proceed past this step until the operator acknowledges that the change has
been completed.
Polarization RF Offset - Because of variations in manufacturing tolerance, it occasionally becomes
necessary to add a small angular value to correct for mechanical error in Polarization. This should
not be adjusted unless the feed has been replaced or repaired. (includes Abs Encoder Offset)
Polarization Motor Scale Factor - Because of variations in manufacturing tolerance, it occasionally
becomes necessary to change the scale factor to correct for mechanical error in Polarization. This
should not be adjusted unless the feed has been replaced or repaired. (includes Abs Encoder Scale
Factor)
Polarization Pos Move Min PWM and Pol Pos Move PWM Factor are factory settings where access
is reserved for field service requirements. Consult AvL technical staff before making changes.
The Polarization CW Limit (Read Only) parameter is the maximum clockwise polarization position
The Polarization CCW Limit (Read Only) parameter is the maximum counter clockwise polarization
position
“User” level limits are specifically designed for the user or integrator so that custom limits can be
created without disabling safety limits built into the system.
6.7 Sensor Override
In the unlikely event that the on-board navigation or tilt sensors in the AvL antenna system become
unreliable, the operator may override them with values manually entered into the control system
through the AAQRemote GUI. The configuration parameters that hold the manually entered values and
the flags that trigger their use are detailed in the following sections.
6.7.1 Compass
Long name
Level
Type
Value Range
Documentation
Magnetic Manual Compass
1
Choice
"No", "Yes"
Flag indicating that the manually entered compass
heading is magnetic rather than a true heading.
Heading for Manual Compass
1
Float
0.0 - 360.0
Heading in degrees to use as the frame heading if
override compass is selected.

AvL Technologies AAQ Antenna Controller Specifications

General

Brand	AvL Technologies
Model	AAQ Antenna Controller
Category	Controller
Language	English