Barudan BEXS - １．Start Point

８‐２
1. Start Point
Instructions on registering the design start point.
Each design can have its own start point.
1. Select a design from the Memory. Use the Jog keys and move the pantograph to the
location where you want to start the design.
2. Press the Drive key to the put the machine in Drive mode. The start point is now
registered for the design. Refer to
2. Drive Mode in this chapter for more information.
*Designs just loaded into memory do not have Start Points, until entered in to Drive.
3. Press the Origin Key to move the Pantograph to the Start Point already registered.
*In the Stand-By state, the Pantograph can move to the Start Point of any selected
design in memory, by pressing the Origin Key.
*If a design has just been loaded, and never entered into Drive mode, the Pantograph
moves to the machine’s origin when the Origin Key is pressed.