11. Reach underneath the thread keep apron and push the thread keep pin forward, so
the thread can go through the hole, then pass the thread through the last eyelet.
12. Optionally, thread the small pigtail that circles the needle, immediately below the
apron. Either pass the thread through from the top, or pass it through the small
opening on the right side of the pigtail.
13. Thread the eye of the needle from front to back and pass the thread through the
large hole in the presser foot.
• After all needles have been threaded, replace the felt pad to avoid kinks
and loops in the thread.
1-10 X Series Mechanical Guide
To Next Page
Loading...