73
of 218
Instruction handbook b maXX BM3000, BM3200, BM3300
Document no. 5.11018.11
6MOUNTING
The device is intended for mounting it into a control cabinet.
Mounting comprises the following steps:
1 Mounting preparation
(for drilling holes, see ZDrilling templates– from page 77)
2 Mounting
the device (for attachment, see ZMounting instruction BM3200, BM3300– on page 83)
6.1 Safety notes
NOTE!
Mounting shall only be performed by employees of the manufacturer or by other qual-
ified personnel.
Qualified personnel are persons who – on account of their occupational training, ex-
perience, instruction and knowledge of relevant standards and stipulations, accident
prevention regulations and operating conditions – are authorized by the persons, re-
sponsible for the safety of the facilities to perform the respective activities that are
necessary, while at the same time recognizing and preventing any potential risks.
The qualifications necessary for working with the device are, for example:
m Occupational training or instruction in accordance with the standards of safety en-
gineering for the care and use of appropriate safety equipment.
To Next Page
Loading...
Need help?
General