Baumuller b maXX 3000 - Display-;Operator Controls Controller BM3200, BM3300 POWERLINK

Design and Function
Instruction handbook b maXX BM3000, BM3200, BM3300
Document no. 5.11018.11
61
of 218
4
POWERLINK
®
Type code BM3200, BM3300 with POWERLINK
®
BM3XXX-XXXX-XXXXX[-X]-4XXXX
[-S0X]-XX[-XX][-EXX][-#XX]
Figure 23: Display-/Operator controls Controller BM3200, BM3300 POWERLINK
®
H1: 7-segment display
display status controller
Meaning see: ZFunction of the 7-segment display–
from page 62
H11 - H14: Status display via LED 
Meaning see: ZFunction of the LEDs H11 to H14– on
page 63
X1: Service interface
S1 - S4: Address switch
Setting: see 
ZSettings address switches– from page 66
H31: LED POWERLINK
®
H32: LED POWERLINK
®
H41: LED POWERLINK
®
H42: LED POWERLINK
®
Meaning: see ZLEDs POWERLINK
®
– on page 65
NOTE!
The service i
nterface X1 must be used with the service cable BM5-K-USB-XXX only,
maximum transmission rate 920 kBaud.