Mounting
Instruction handbook b maXX BM3000, BM3200, BM3300
Document no. 5.11018.11
77
of 218
6
6.3 Drilling templates
How to determine the required space in the control cabinet, see ZDimensions– from
page 23.
Use the drilling templates to make the necessary drill holes.
Tolerance
specifications
NOTE!
Consider the minimum clearances for cooling when making the drill holes.
Further notes see ZDimensions– from page 23 and ZCooling– from page 34.
NOTE!
m Assembly permitted in the displayed position only (vertical with air cooling from the
bottom to the top).
m A lining up of several devices next to each other is possible. Comply with the
specified clearance of 100 mm above and below the device, so that the air circu-
lation for heat dissipation is guaranteed.
NOTE!
All dimensions in mm.
Drill hole dimensioning ±0.2 mm
Relative tolerance of discretionary divisions ±0.1 mm
To Next Page
Loading...