8-12
If, for example you wanted to add DEAL into the existing flight plan going from MANSTON to DOVER
VOR shown in the illustration above, you would first position the pointer over the track line between
Manston and Dover VOR, thereby highlighting it and then press Key 2, GRAB LINE. This will pick up
the line. You would then move the pointer, stretching the track line like a rubber band, until it was over
DEAL and press Key 2, ADD WPT.. The new track line would then be set joining MANSTON to DEAL
to DOVER VOR and the numbers shown next to DOVER VOR and all subsequent waypoints would be
increased by one. DEAL would become 01, DOVER VOR 02 etc.
If, for example you wanted to add HERNE BAY to the end of the flight plan illustrated above, simply
move the pointer over MANSTON, thereby highlighting it and then press Key 2, ADD WPT. This will
draw a line from Manston to the pointer. Next move the pointer until it is over HERNE BAY, highlight it
and press Key 2, ADD WPT again.
To delete a waypoint from a flight plan, point at the item you wish to remove and press Key 5, DELETE
WPT. To delete a newly created user waypoint, you have to return to Screen 9, Manual User waypoint
Edit Screen, or 10, View and Edit User waypoints on the Map Screen. You can create user waypoints
on Screen 19 but not delete them from there.
To Next Page
Loading...