2-2
GPS STATUS Shows satellite signal strength, allows UTC, local offset, date and position to be set,
which will speed up the initialisation of your unit.
FLIGHT PLAN Allows user defined user waypoints and flight plans to be edited/created.
EDIT FPLN Allows user defined flight plans to be edited /created either manually
or visually.
USER WPTS Allows user defined user waypoints, airports and marker functions to
be edited/created either manually or visually.
DEMO MODE Allows you to practice operating the unit on the ground using a built-in simulator.
NOTE PAD Allows up to 4000 characters of text, previously downloaded from a PC using Flight
Manager™ software to be viewed. This Key is only available if DEMO MODE is not
running. DEMO MODE can only be selected from the first screen after switching on
the unit.
E6-B CALC Allows the E6-B Calculator to be used.
TAS/WIND Allows density altitude, TAS and winds aloft to be calculated.
V NAV Allows vertical navigation to be Setup.
TRIP/FUEL Allows fuel and trip information to be calculated.
SUNSET/RISE Allows sunset and sunrise times to be calculated.
SETUP Allows Setup of map, navigation and input/output characteristics.
MAP SETUP Allows all map functions to be customised, including map tracking,
airport names, map units, map datum, display orientation, language,
minimum runway length/surface, extended track, auto zoom and
zoom level map de-clutter facility.
NAV SETUP Allows all the NAV functions to be customised, including CDI scale,
CDI display, CDI alarm, arrival alarm, auto next leg/leg selection
philosophy, turn anticipation and logging rate.
PIN SETUP Allows the PIN security function to be Setup.
INST & DIAGS Allows installation and diagnostics for data input/output and GPS
receiver (Skymap IIIC only) to be performed. Flight logs can be
viewed and various sections of memory can be cleared from here.
To Next Page
Loading...