BERTHOLD TECHNOLOGIES LB 480 - 2.49 Access

54733-10BA2L
3 – 376 02.2017
Menu Structure Volume 3
2.49 Access
Menu path: Device Config  Access.
On this menu you can enter the password, enable write protection
to prevent configuration changes and activate the safety mode.
1 Password Enter a password to protect the detector against unauthorized
access. Then access to editable parameters is disabled. To undo the
protection again, you must enter the password again.
You can choose any password you want; it may comprise a maxi-
mum of 8 characters or digits.
Possibly activated test settings are reset when enabling password
protection.
Tip
Write down your password to be able to unlock the detector later.
Please contact BERTHOLD TECHNOLOGIES if you lose your pass-
word.
2 Write Protect Indicates whether the detector is protected against changes in the
settings (parameters).
• NO
The detector is not write protected, so that the settings can be
edited.
• YES
The detector is write protected; settings cannot be edited, but
they can still be displayed.
3 Safety Mode Indicates whether the safety mode is enabled:
• ON
Safety mode is enabled.
• OFF
Safety mode is disabled.