54733-10BA2L
3 – 380 02.2017
Menu Structure Volume 3
2.53 Device Revision
Menu path: Device Config Identification Device Revision.
This menu shows the hardware and software revisions.
1 Universal Rev Shows the revision of the specific universal HART
®
command set.
For the SENSseries you need the Universal Commands for HART
®
6
or higher. This requires that the 375 Field Communicator of the
Emerson Process Management GmbH & Co. OHG or a compatible
model is used which supports enhancements.
If the Communicator has a lower version than HART
®
6, then the
so-called Generic DD will be started. The Generic DD does have a
HART
®
-specific command set, but this does not sufficient for the
SENSseries.
2 Field Dev Rev Shows the compatibility of the detector with DD on the Communi-
cator. This number, e.g. 2, indicates that DD Revision 2 is necessary
which supports the full functional range of the detector. See also
chapter 7.7, page 3-424.
3 Software Rev Displays the software revision (embedded software). This informa-
tion depends on the currently installed firmware and cannot be
changed.
4 SW Revision Software revision with presentation according to NAMUR.
5 SW Revision Date Date of the software revision.
4 Hardware Rev Shows the hardware revision. This information is set up by
BERTHOLD TECHNOLOGIES and edited be changed by the user.
To Next Page
Loading...
