SENSseries LB 480 Level measurement
BERTHOLD TECHNOLOGIES GmbH & Co. KG
2 – 227
Volume 2 4 Repair, Maintenance and Upkeep
2
4 Repair, Maintenance and
Upkeep
Spare parts for detectors used in the Ex-area must be mounted
solely by the BERTHOLD TECHNOLOGIES service or by persons
authorized by BERTHOLD TECHNOLOGIES. If this is not possible,
you must replace the entire detector or return it to the manufac-
turer for repair.
For devices that are NOT used in an Ex-area, the following parts
may be replaced at your own risk and taking into account a loss of
any existing warranty by BERTHOLD TECHNOLOGIES:
– the complete detector electronics
– the complete connection head
– the crystal at the CrystalSENS
– the multiplier (PMT)
– the multiplier crystal combination
– the detector housing
BERTHOLD TECHNOLOGIES recommends to have detectors
repaired solely by the BERTHOLD TECHNOLOGIES service or by per-
sons authorized by BERTHOLD TECHNOLOGIES.
Only original spare parts by BERTHOLD TECHNOLOGIES may be
used.
Please follow the instructions in the Safety Manual (Volume 1) and
the instructions in chapter 3, "Electrical Installation", page 2-217.
After every repair, maintenance or upkeep, please use the check-
lists on page 1-51 and page 1-53.
To Next Page
Loading...
