SENSseries LB 480 Level measurement
BERTHOLD TECHNOLOGIES GmbH & Co. KG
3 – 441
Volume 3 9 Setup Protocol
3
9 Setup Protocol
For reasons of clarity, only those parameters are listed in the fol-
lowing list which have a decisive influence on the measured signal.
As an alternative to completing the list below, you can also transfer
and print the data digitally, via the HART
®
signal. See also chapter
1.5, "Archiving Parameter Sets", page 3-303.
After commissioning, enter the parameters in the following
parameter list in order to document the start-up.
TAG No. Date
Isotope Activity
Source no. Detector
Product HV
Path Parameters Unit Standard SETUP
Device Config Meas Parameter Meas Data
Background cps 50
Device Config Meas Parameter Meas Data Meas Table
Point Level Rate Rate at Op Comp Rate
1
2
3
4
5
6
7
8
9
10
11
To Next Page
Loading...
