BERTHOLD TECHNOLOGIES LB 480 - 2.54 Diagnostic

SENSseries LB 480 Level measurement
BERTHOLD TECHNOLOGIES GmbH & Co. KG
3 – 381
Volume 3 Menu Structure
3
2.54 Diagnostic
This menu provides status and error information and allows you to
view the error logs and setting changes logs (parameter changes).
Tip
In chapter 8 on page 3-429 you find a list of possible causes and
troubleshooting procedures.
1 Operating Status Opens the menu showing the operating status (page 3-382).
2 Log Opens the menu showing the logs for error and setting changes
(page 3-387).
3 Safety The status of all settings listed here must be OFF when you have
enabled Safety ON (Device Config  Access, page 3-376).
4 Slave Status Shows on which slave there is currently an error.
A list of 16 slave detectors with error status is displayed.
• OFF = error free
• ON = an error is indicated
Tip
If an error is present, you can select the respective slave under
Diagnostic  Error Log and you can read out the error status of
the respective detector.
5 Error Status 100 … 907 Here you can check the status of all error messages that are possi-
ble in the detector.
•OFF = error free
•ON = an error is indicated