USE
MAINTENANCE
3
Move several times the lever or the brake pedal to fill the circuit and bleed the air.
Connect to the bleeding valve (3) or (5) the brake bleeding device.
NOTES
When using a brake bleeding device, follow the manufacturer’s instructions.
Pump with the bleeding device and loosen the bleed valve (3) or (5) checking always that the level
does not fall below the MIN.
Repeat this step until any more air bubbles does not appear in the transparent hose connected to
the bleeding valve.
Block the draining valve (3) or (5) to the torque wrench recommended.
In case of a bleeding device is not available, connect a transparent plastic hose to the drain valve
(3) or (5) as described for the brake circuit bleeding.
Sub 3-25
To Next Page
Loading...
