USE
MAINTENANCE
3
Open the draining valve (3) or (5) of ¼ of turn and operate the lever or the brake pedal until fluid
begins to exit from the valve then close the draining valve. Pull completely the lever or pedal then
loosen the bleeding valve at least of ¼ of turn.
Wait a few seconds; close the draining valve (3) or (5) then slowly release the lever or the pedal.
IMPORTANT
Don't release the lever or the brake pedal if the valve is not very tight.
Repeat this operation until the plastic hose will come out liquid free of bubbles.
Make the bleeding operation acting on a valve at a time.
Lock to the torque required the bleeding valve (3) or (5) and install the protective cap.
To completely remove the air that may remain in the highest point of the front brake pump, act the
same way on the bleeding valve (6). Level the brake fluid in the reservoir.
Sub 3-26
To Next Page
Loading...
