104
Troubleshooting
Problems with the memory card
No memory card inserted
❍ Are you using a 5 V type SmartMedia card?
The BR-532 requires the use of 3.3 V type SmartMedia
cards.
“Unsupported Media!” is displayed
❍ Do you have a compatible (SmartMedia) memory card
inserted in the BR-532?
❍ Is the (SmartMedia) memory card fully and securely
inserted?
Synchronization problems
(Cannot synchronize)
When using MTC to synchronize the BR-532 with a MIDI
sequencer, the BR-8 must be the master device.
❍ Is the MIDI cable connected correctly?
❍ Is the MIDI cable broken?
❍ Is the device ID number correct?
❍ Has the sync generator been set to the desired
synchronization procedure (MTC or MIDI Clock)? (p.
69)
❍ If you are synchronizing with MTC, has the other
device been set to the same MTC type? (p. 69)
❍ If using the sync track, is MIDI clock recorded to the
sync track?
❍ Has the MIDI sequencer been set correctly?
❍ Is the MIDI sequencer ready to play back?
❍ Does the other device support the MMC commands of
the BR-532?
Other problems
Memory card data was damaged
If memory card data has been damaged, the following causes
are possible. Please initialize the card once again. (p. 61)
❍ Was the power turned off while the recorder was
operating?
❍ Was a strong physical shock applied to the memory
card?
❍ Could the power have been turned off while the
memory card was being accessed?
❍ Was the card initialized on a PC or digital camera?
To Next Page
