Boss BR-532 - Track Editing - Moving Complete Track; Moving a Complete Track (ALL)

54
Editing the performance on a track (Track Editing)
1. Press [UTILITY].
2. Press PARAMETER [ ] [ ] to move the cursor to
“TRK,” and press [ENTER].
fig.R08-02
3. Press PARAMETER [ ] [ ] to move the cursor to
“MOV,” and press [ENTER].
fig.R08-13
4. Turn the TIME/VALUE dial to select “TIME/MES” and
press [ENTER].
fig.R08-16c
5. Press PARAMETER [ ] [ ] to move the cursor,
and turn the TIME/VALUE dial to select the track/V-
Track to move from, and track/V-Track to move to.
6. Press [ENTER].
fig.R08-16d
7. Press PARAMETER [ ] [ ] to move the cursor,
and turn the TIME/VALUE dial to specify the
beginning of the portion of data you want to move.
8. Press [ENTER].
fig.R08-17a
9. Press PARAMETER [ ] [ ] to move the cursor,
and turn the TIME/VALUE dial to specify the ending
of the portion of data you want to move.
10.Press [ENTER].
fig.R08-17b
11.Press PARAMETER [ ] [ ] to move the cursor,
and turn the TIME/VALUE dial to specify the time of
the beginning of the location where you want the data
moved.
12. When you are ready to execute the move, press [ENTER].
The display will ask “Are you sure?,” so that you can
confirm the operation.
13.Press [ENTER].
Move Event is executed.
14.Press [EXIT] several times to return to the Play page.
* After specifying the time in the procedure above, if you change
the display to show measures (p. 50), a “+” may appear to
show that there is a discrepancy between the actual current
position and the position displayed. If you specify the locations
using measures, specify the locations at each screen using the
TIME/VALUE dial to eliminate the discrepancy.
You can also enter the time using [LOCATOR], [ZERO], [STOP]
+ [REW], [STOP] + [FF], and AUTO PUNCH [IN/OUT].
Moving a complete track (ALL)
Perform the procedure given below to move the complete
recorded data from one track to another.
1. Press [UTILITY].
2. Press PARAMETER [ ] [ ] to move the cursor to
“TRK,” and press [ENTER].
fig.R08-02
3. Press PARAMETER [ ] [ ] to move the cursor to
“MOV,” and press [ENTER].
fig.R08-13
4. Turn the TIME/VALUE dial to select “ALL” and press
[ENTER].
fig.R08-18a
5. Press PARAMETER [ ] [ ] to move the cursor,
and turn the TIME/VALUE dial to select the track/V-
Track to move from, and track/V-Track to move to.
6. Press [ENTER].
fig.R08-18b