Boss BR-532 - Track Editing - Erasing by Time;Complete Track; Erasing by Specifying Time (TIME;MES); Erasing a Complete Track (ALL)

56
Editing the performance on a track (Track Editing)
6. When you are ready to execute the erasure, press [ENTER].
The display will ask “Are you sure?,” so that you can
confirm the operation.
7. Press [ENTER].
The erasure is executed.
8. Press [EXIT] several times to return to the Play page.
Erasing by specifying the time
(TIME/MES)
Perform the procedure given below to erase the portion
between specific times.
fig.R08-22a
1. Press [UTILITY].
2. Press PARAMETER [ ] [ ] to move the cursor to
“TRK,” and press [ENTER].
fig.R08-02
3. Press PARAMETER [ ] [ ] to move the cursor to
“ERS,” and press [ENTER].
fig.R08-20
4. Turn the TIME/VALUE dial to select “TIME/MES” and
press [ENTER].
fig.R08-22b
5. Press PARAMETER [ ] [ ] to move the cursor,
and turn the TIME/VALUE dial to select the track/V-
Track to erase from.
6. Press [ENTER].
fig.R08-23
7. Press PARAMETER [ ] [ ] to move the cursor,
and turn the TIME/VALUE dial to specify the
beginning of the portion of data you want to erase.
8. Press [ENTER].
fig.R08-24
9. Press PARAMETER [ ] [ ] to move the cursor,
and turn the TIME/VALUE dial to specify the ending
of the portion of data you want to erase.
10.When you are ready to execute the erasure, press
[ENTER].
The display will ask “Are you sure?,” so that you can
confirm the operation.
11.Press [ENTER].
The erasure is executed.
12.Press [EXIT] several times to return to the Play page.
* After specifying the time in the procedure above, if you change
the display to show measures (p. 50), a “+” may appear to
show that there is a discrepancy between the actual current
position and the position displayed. If you specify the locations
using measures, specify the locations at each screen using the
TIME/VALUE dial to eliminate the discrepancy.
You can also enter the time using [LOCATOR], [ZERO],
[STOP] + [REW], [STOP] + [FF], and AUTO PUNCH
[IN/OUT].
Erasing a complete track (ALL)
1. Press [UTILITY].
2. Press PARAMETER [ ] [ ] to move the cursor to
“TRK,” and press [ENTER].
fig.R08-02
3. Press PARAMETER [ ] [ ] to move the cursor to
“ERS,” and press [ENTER].
fig.R08-20
START END Time