26
Listening to the Demo Song
Changing the current position
Elapsed time display
The value given at “TIME” in the display shows the elapsed
time into the song using MTC (MIDI time codes) and is
expressed as follows: hours-minutes-seconds-frames-sub
frames.
The time code specifications can differ depending on the
device. To synchronize operation with another device using
MTC, you will first need to match the time code
specifications of both devices. At the factory settings, one
second is set to 30 frames (non-drop) (p. 70).
Moving to the start of a play
To move to the time where the first sound of a song is
recorded, press and hold [STOP] and press [REW].
Each V-Track of the selected track is checked and you move
to the time of the first recorded sound for the song.
Press [ZERO] to jump to the beginning of the song.
Moving to the end of a play
To move to the time where the last sound of a song is
recorded, press and hold [STOP] and press [FF].
Each V-Track of the selected track is checked and you move
to the time of the last recorded sound for the song.
Moving through a song using hours,
minutes, seconds, frames, or sub frames
Press PARAMETER [ ] [ ] to move the cursor to hours,
minutes, seconds, frames, or sub-frames display, and turn the
TIME/VALUE dial to change the current time in the song.
Moving through a song in measures or
beats
The current position’s measure number and beat number are
displayed at the location labeled “MEASURE” in the display.
* For the demo songs, a pattern (p. 62) has already been created
(SNG) and it is set so that measure numbers, beat numbers,
and pattern are properly synchronized.
Press PARAMETER [ ] [ ] to move the cursor to
MEASURE display, and turn the TIME/VALUE dial to
change the current measure or beat number in the song.
To Next Page
Loading...
