Contains Lockout Status code
and Current system mode
Cold Junction Compensation
Temperature
Current Process Rate
Value
Maximum Process Rate Value
Minimum Process Rate Value
Current Target Value of
set point
Notes
*B: The ranges of some parameters are dependent on the input types. The range of IN1 and IN2 for
various input type is shown in the following table
5-1 PID Process Control Card Input Types
*B1: Range for A1SP & A2SP
Range of A1SP same as range of
P1.2 H,P1.2 L,D1.2 H ,D1.2 L
Range of A2SP same as range of
P1.2 H,P1.2 L,D1.2 H ,D1.2 L
5-3 A2SP Range
*B2: Range for SP2
To Next Page
Loading...
Need help?
General
