Brocade Communications Systems FastIron X Series User Manual

• set metric-type type-1 | type-2
• set tag tag-value
NOTE
You must congure the route map before you congure a redistribution lter that uses the route
map.
NOTE
When you use a route map for route redistribution, the software disregards the permit or deny action of the route map.
NOTE
For an external route that is redistributed into OSPFv3 through a route map, the metric value of the route remains the same
unless the metric is set by a set metric command inside the route map or the default-metric command. For a route
redistributed without using a route map, the metric is set by the metric parameter if set or the default-metric command if the
metric parameter is not set.
Modifying default metric for routes redistributed into OSPF Version 3
The default metric is a global parameter that
species the cost applied by default to routes redistributed into OSPFv3. The default value
is 0.
If the metric parameter for the redistribute command is not set and the default-metric command is not set, the metric is set to 1, its
default value, then routes redistributed from the various routing protocols will have the metric value of the protocol from which they are
redistributed.
NOTE
You also can dene the cost on individual interfaces. The interface cost overrides the default
cost.
To assign a default metric of 4 to all routes imported into OSPFv3, enter the following command.
device(config-ospf6-router)# default-metric 4
Syntax: [no] default-metric number
You can specify a value from 0 - 65535. The default is 0.
To restore the default metric to the default value, use the no form of this command.
Modifying metric type for routes redistributed into OSPFv3
The device uses the metric-type parameter by default for all routes redistributed into OSPFv3 unless you specify a
dierent metric type
for individual routes using the redistribute command.
A type 1 route species a small metric (two bytes), while a type 2 route species a big metric (three bytes). The default value is type 2.
To modify the default value of type 2 to type 1, enter the following command.
device(config-ospf6-router)# metric-type type1
Syntax: [no] metric-type {type1 | type2}
To restore the metric type to the default value, use the no form of this command.
Conguring OSPFv3
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 303

Brocade Communications Systems FastIron X Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron X Series
Category	Switch
Language	English