• Required - Specify the local AS number.
• Optional - Add a loopback interface for use with neighbors.
• Required - Identify BGP4 neighbors.
• Optional - Change the Keep Alive Time and Hold Time.
• Optional - Change the update timer for route changes.
• Optional - Enable fast external fallover.
• Optional - Specify a list of individual networks in the local AS to be advertised to remote autonomous systems using BGP4.
• Optional - Change the default local preference for routes.
• Optional - Enable the default route (default-information-originate).
• Optional - Enable use of a default route to resolve a BGP4 next-hop route.
• Optional - Change the default MED (metric).
• Optional - Enable next-hop recursion.
• Optional - Change the default administrative distances for EBGP, IBGP, and locally originated routes.
• Optional - Require the rst AS in an Update from an EBGP neighbor to be the neighbor AS.
• Optional - Change MED comparison parameters.
• Optional - Disable comparison of the AS-Path length.
• Optional - Enable comparison of the device ID.
• Optional - Enable auto summary to summarize routes at an IP class boundary (A, B, or C).
• Optional - Aggregate routes in the BGP4 route table into CIDR blocks.
• Optional - Congure the device as a BGP4 route reector.
• Optional - Congure the device as a member of a BGP4 confederation.
• Optional - Change the default metric for routes that BGP4 redistributes into RIP or OSPF.
• Optional - Change the parameters for RIP, OSPF, or static routes redistributed into BGP4.
• Optional - Change the number of paths for BGP4 load sharing.
• Optional - Change other load-sharing parameters
• Optional - Dene BGP4 address lters.
• Optional - Dene BGP4 AS-path lters.
• Optional - Dene BGP4 community lters.
• Optional - Dene IP prex lists.
• Optional - Dene neighbor distribute lists.
• Optional - Dene BGP4 route maps for ltering routes redistributed into RIP and OSPF.
• Optional - Dene route ap dampening parameters.
NOTE
When using the CLI, you set global level parameters at the BGP CONFIG level of the CLI. You can reach the BGP CONFIG
level by entering the router bgp command at the global CONFIG level.
Some parameter changes take eect immediately while others do not take full eect until the device sessions with its neighbors are reset.
Some parameters do not take eect until the device is rebooted.
BGP4 parameters
FastIron Ethernet Switch Layer 3 Routing
362 53-1003627-04
To Next Page
Loading...
Need help?
General
