Brocade Communications Systems FastIron X Series User Manual

NOTE
Use soft-outbound only if the outbound policy is changed. The soft-outbound parameter updates all outbound routes by
applying the new or changed lters. However, the device sends to the neighbor only the existing routes that are aected by the
new or changed lters.The soft out parameter updates all outbound routes and then sends the entire BGP4 route table on the
device to the neighbor after the device changes or excludes the routes aected by the lters.
AS4 notation
A AS4 can appear in either a plain or a dot notation format in the output of show commands. To select one of these formats, specify the
format before entering the show command. This section denes these formats and describes how to select a format. The following
notations are currently supported:
• With the default asplain , the ASN is a decimal integer in the range 1 - 4294967295.
• With asdot +, all ASNs are two integer values joined by a period character in the following format:
<high order 16-bit value in decimal>.<low order 16-bit value in decimal>
Using the asdot+ notation, an autonomous system number of value 65526 is represented as the string "0.65526," and an autonomous
system number of value 65546 is represented as the string "1.10."
• With asdot, an ASN less than 65536 uses the asplain notation (and represents autonomous system number values equal to or
greater than 65536 using the asdot+ notation). Using the asdot notation, ASN 65526 is represented as the string "65526,"
and ASN 65546 is represented as the string "1.10".
NOTE
You can enter autonomous system numbers in any format. However, if you want the asdot or the asdot+ format to appear in the
output of a show command, you must specify these in the CLI.
NOTE
Remember that autonomous system path matching that uses regular expression is based on the congured autonomous
system format.
The following command sequences show how to enable the dierent notations for AS4s and how these notations appear in the output
display.
To see ASNs in asplain, use the show ip bgp command.
device(config)# show ip bgp
Total number of BGP Routes: 1
Status codes:s suppressed, d damped, h history, * valid, > best, i internal, S stale
Origin codes: i - IGP, e - EGP,? - incomplete
Network Next Hop Metric LocPrf Weight Path
*> 47.1.1.0/24 192.168.1.5 1 100 0 90000 100 200 65535 65536 65537 65538 65539 75000 ?
To specify asdot notation before displaying IP BGP4 information, use the as-format command.
device(config)# as-format asdot
device(config)# show ip bgp
Total number of BGP Routes: 1
Status codes: s suppressed, d damped, h history, * valid, > best, i internal, S stale
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*> 10.1.1.0/24 192.168.1.5 1 100 0 1.24464 100 200 65535
1.0 1.1 1.2 1.3 1.9464 ?
Syntax: [no] as-format asplain | asdot | asdot+
The default is asplain and can be restored using the no version of the command, if the CLI is currently using asdot or asdot+ .
Four-byte Autonomous System Numbers (AS4)
FastIron Ethernet Switch Layer 3 Routing
422 53-1003627-04

Brocade Communications Systems FastIron X Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron X Series
Category	Switch
Language	English