2-10
Confidential
Error
Code
Contents
Refer to
page:
28 Replace cyan ink cartridge. (Detected by the cyan ink remaining sensor) 2-29
29 Replace magenta ink cartridge. (Detected by the magenta ink remaining sensor) 2-29
2A Black ink cartridge not loaded. (Detected by the ink cartridge detection sensor) 2-30
2B Yellow ink cartridge not loaded. (Detected by the ink cartridge detection sensor) 2-30
2C Cyan ink cartridge not loaded. (Detected by the ink cartridge detection sensor) 2-30
2D
Magenta ink cartridge not loaded. (Detected by the ink cartridge detection
sensor)
2-30
2F Ink cartridge cover opened. 2-31
30 Carriage motor does not rotate. (Detected by the CR encoder) 2-31
31 Cannot detect the origin of the carriage. (Detected by the CR encoder) 2-32
32 Capping load large. 2-32
35
Head/carriage unit stopped during printing. (Error caused by any problem
except a paper jam when ink is not being jetted out)
2-33
38
Head/carriage unit stopped during printing. (Error caused by a paper jam when
ink is not being jetted out)
2-33
3B
Head/carriage unit stopped during printing. (Error caused by any problem
except a paper jam when ink is being jetted out)
2-34
3C
Head/carriage unit stopped during printing. (Error caused by a paper jam when
ink is being jetted out)
2-34
3E Any abnormality in the carriage motor, ASF motor, or paper feed motor. 2-35
3F Carriage motor does not stop. (Keeps rotating for 10 seconds or more) 2-35
40 Casing internal thermistor defective. (Detects -20ºC or below or 80ºC or higher) 2-36
42 Head drive voltage dropped below the lower limit. 2-36
43
Head thermistor defective. (Detects -20ºC or below or 80ºC or higher when the
power is turned on)
2-36
44 Abnormal temperature of the print head driver. 2-37
46 Purge count or flushing count overflown. 2-37
48 Head flat cables halfway connected. 2-37
49 Abnormal head drive voltage. (Does not rise to the specified level) 2-38
4F
The head drive voltage has dropped from the high to low level in an abnormally
short period.
2-38
50 Purge cam switch does not come ON or go OFF. 2-38
52
Failed to detect the origin of the purge cam. (Failed to detect the longest OFF
domain of the purge cam)
2-39
To Next Page
Loading...
