Cutting Roll Paper After Printing (Mac OS)
Cutting Roll Paper After Printing (Mac OS)
This topic describes how to cut roll paper automatically after printing (using the auto cut function), as well as how to
print a cut line for manual cutting.
Note
• The auto cut function is activated on the printer by default and when the printer driver is installed. Follow the steps below to
reactivate the function if it is disabled, or to select the setting for printing a cut line instead.
1
This sets the B Format for and C Paper Size.
Note
•
The configuration method varies depending on the OS and
application software you are using.
If Page Setup is displayed in the application menu, the set-
tings are configured by opening the Page Attributes dialog
box from Page Setup.
If it is not displayed, the settings are configured in the upper
part of the printer driver displayed when you select Print from
the application software menu.
2
Select the printer in the A Printer list.
3
Choose the original size in the F Paper Size list.
4
If you configured the settings using the Page Attributes dialog box, click F OK to close the dialog box, and
then select Print from the application software menu.
5
Access the Page Setup pane.
6
Select and click a roll paper in the A Paper Source list.
iPF6400S
Cutting Roll Paper After Printing (Mac OS)
User's Guide
Enhanced Printing Options Other useful settings
157
To Next Page
Loading...
Need help?
General