•
The Power Lamp and Message Lamp are not lit (even once), and nothing appears on the Display
Screen
Make sure the printer is plugged in correctly. Check the connection at the plug and electrical outlet.
Important
• Starting the printer when it is connected via the USB cable to a Macintosh computer that is off may cause the computer to
start up at the same time. To prevent this, disconnect the USB cable before starting the printer. Connecting the printer to the
computer via a USB hub may solve this issue.
Turning the printer off
Important
• Never disconnect the printer's power supply or unplug it during a print job. This may damage the printer.
1
Make sure no print jobs are in progress.
If the Message Lamp is flashing, check the message on the Display
Screen and take action as necessary. (See "Error Messag-
es.") âž” P.970
If the Data Lamp is flashing, the printer is receiving a print job. Turn
off the printer only after printing is finished.
2
Hold down the Power button for more than a second.
After "Shut Down.. Please Wait.." is shown on the Display Screen,
the printer shuts off.
Loading and Printing on Rolls
Loading and Printing on Rolls
These are the basic steps for loading and printing on rolls.
Follow these steps to load and print on rolls.
•
If you use the optional Stand, you can store printed documents in the Output Stacker. see "Using the Output Stack-
er." âž” P.547
•
You also can install and use the printer on a table, etc., instead of using the Stand.
Loading and Printing on Rolls
iPF6400S
User's Guide
Basic Printing Workflow Printing procedure
22
To Next Page
Loading...
Need help?
General