2
Load the paper.
(See "Loading Rolls on the Roll Holder.") ➔ P.507
(See "Loading Rolls in the Printer.") ➔ P.509
Note
• If Adj. Quality has not been executed even once on the paper you are using, execute Adj. Quality in the Control
Panel menu.
(See "Automatic Banding Adjustment.") ➔ P.771
3
Select the White/Black Backing Plate color.
(See "Switching the White/Black Backing Plate (Optional) Color.") ➔ P.804
Note
• For the color of the White/Black Backing Plate, select the color from when color calibration was executed using the
Spectrophotometer Unit.
(See "Color Calibration Using the Spectrophotometer Unit (option).") ➔ P.799
4
Select the pattern size.
Set Pattern Size in the Control Panel menu.
(See "Menu Settings.") ➔ P.634
Note
• To increase the precision of the color check, select the Pattern Size from when color calibration was executed using
the Spectrophotometer Unit.
(See "Color Calibration Using the Spectrophotometer Unit (option).") ➔ P.799
•
Executing a Color Check from the Control Panel
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect (Settings/Adj. tab).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button.
Set./Adj. Menu is displayed.
3
Press ▲ or ▼ to select Adjust Printer, and then press the OK button.
4
Press ▲ or ▼ to select Calibration, and then press the OK button.
5
Press ▲ or ▼ to select ColorCheck Print and then press the OK button.
The printer then measures environmental conditions, checks the paper, and executes a Color Check.
6
The results of the Color Check are shown on the Control Panel.
If the color measurement results exceed the threshold values, we recommend executing color calibration.
Using the Color Calibration Management Console Management Functions
The Color Calibration Management Console provides the following management functions.
•
Detailed execution information
•
Execution instructions from the computer
iPF6400S
Color Checks Using the Spectrophotometer Unit (option)
User's Guide
Color Management Color Calibration
803
To Next Page
Loading...
