Manual Operation
3-27
1. Tap “Menu”, “Configuration” and “Interface:” to select LAN to as shown in Figure 3-37, Figure
3-38, and Figure 3-40.
2. Tap LAN to enter into the address setting screen.
Auto Detect:
The default of DHCP is ON. Swipe left to second page as Figure 3-44 shows, the DC Power
Supply will automatically detect external network address.
Manual Detect:
1. Tap DHCP to set it to OFF.
2. Tap IP ADDR and set it.
3. Tap SUBNET MASK and set it.
4. Swipe left to the second page, tap GATEWAY ADDR and set it.
5. Tap “Apply” and wait for connection.
6. Touch the upper left corner to enter into Menu page.
7. Tap “MEAS. & Setup” to return to the main page.
Figure 3-43
To Next Page
Loading...
