Cisco Catalyst 3120 Command Reference Guide

2-13
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
archive download-sw
Defaults The current software image is not overwritten with the downloaded image.
Both the software image and HTML files are downloaded.
The new image is downloaded to the flash: file system.
The BOOT environment variable is changed to point to the new software image on the flash: file system.
Image names are case sensitive; the image file is provided in tar format.
Compatibility of the stack protocol version on the image to be downloaded is checked with the version
on the switch stack.
Command Modes Privileged EXEC
Command History
Usage Guidelines Use the /allow-feature-upgrade option to allow installation of an image with a different feature set, for
example, upgrading from the IP base feature set to the IP services feature.
You can use the archive download-sw /directory command to specify a directory only once, followed
by a tar file or list of tar files to be downloaded, instead of specifying complete paths with each tar file.
For example, in a mixed hardware stack, you can enter archive download-sw /directory
tftp://10.1.1.10/ cbs31x0-universal-tar.122-40.EX.tar cbs31x0-universal-tar.122-40.EX1.tar.
The /imageonly option removes the HTML files for the existing image if the existing image is being
removed or replaced. Only the Cisco IOS image (without the HTML files) is downloaded.
Using the /safe or /leave-old-sw option can cause the new image download to fail if there is insufficient
flash memory. If leaving the software in place prevents the new image from fitting in flash memory due
to space constraints, an error results.
If you used the /leave-old-sw option and did not overwrite the old image when you downloaded the new
one, you can remove the old image by using the delete privileged EXEC command. For more
information, see the “delete” section on page 2-72.
Use the /no-version-check option if you want to download an image that has a different stack protocol
version than the one existing on the switch stack. You must use this option with the /destination-system
option to specify the specific stack member to be upgraded with the image.
Note Use the /no-version-check option with care. All stack members, including the stack master, must have
the same stack protocol version to be in the same switch stack. This option allows an image to be
downloaded without first confirming the compatibility of its stack protocol version with the version of
the switch stack.
You can upgrade more than one specific stack member by repeating the /destination-system option in
the command for each stack member to be upgraded.
Use the /overwrite option to overwrite the image on the flash device with the downloaded one.
Release Modification
12.2(40)EX This command was introduced.

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English