Index
IN-5
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
DSCP-to-DSCP-mutation map 2-279
DTP 2-696
DTP flap
error detection for
2-122
error recovery timer 2-124
DTP negotiation 2-700
dual IPv4 and IPv6 templates 2-327
duplex command 2-120
dynamic-access ports
configuring
2-688
restrictions 2-689
dynamic ARP inspection
ARP ACLs
apply to a VLAN
2-149
define 2-20
deny packets 2-73
display 2-387
permit packets 2-325
clear
log buffer
2-51
statistics 2-52
display
ARP ACLs
2-387
configuration and operating state 2-461
log buffer 2-461
statistics 2-461
trust state and rate limit 2-461
enable per VLAN 2-159
error detection for 2-122
error recovery timer 2-124
log buffer
clear
2-51
configure 2-153
display 2-461
rate-limit incoming ARP packets 2-151
statistics
clear
2-52
display 2-461
trusted interface state 2-155
dynamic ARP inspection (continued)
type of packet logged
2-160
validation checks 2-157
dynamic auto VLAN membership mode 2-695
dynamic desirable VLAN membership mode 2-695
Dynamic Host Configuration Protocol (DHCP)
See DHCP snooping
Dynamic Trunking Protocol
See DTP
E
EAP-request/identity frame
maximum number to send
2-111
response time before retransmitting 2-117
encapsulation methods 2-715
environment variables, displaying 2-392
errdisable detect cause command 2-122
errdisable recovery command 2-124
error conditions, displaying 2-434
error disable detection 2-122
error-disabled interfaces, displaying 2-446
EtherChannel
assigning Ethernet interface to channel group
2-38
creating port-channel logical interface 2-134
debug EtherChannel/PAgP, display B-8
debug platform-specific events, display B-32
displaying 2-437
enabling Layer 2 protocol tunneling for
LACP
2-225
PAgP 2-225
UDLD 2-225
interface information, displaying 2-446
LACP
clearing channel-group information
2-57, 2-58
debug messages, display B-16
displaying 2-506
modes 2-38
port priority for hot-standby ports 2-228
To Next Page
Loading...
Need help?
General