Cisco CRS-1 - Carrier Routing System Router Getting Started Guide

Contents
viii
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
Configuration Examples for Managing Packages 6-30
Copying and Adding a Package to the Router: Example 6-30
Activating and Testing a Package on the Router: Example 6-31
Activating a Package on the Router: Example 6-33
CHAPTER 7 RP Redundancy and Hardware Administration on Cisco IOS XR Software 7-1
Contents 7-1
Commands to Display Hardware Status 7-1
Examples of Hardware Show Commands 7-2
Command Syntax for Hardware Nodes (location nodeID) 7-4
Configure Routing Interfaces 7-7
Physical Components of Routing Interfaces 7-7
Configuring Interfaces in the Cisco IOS XR Software 7-11
RP Redundancy and Failover 7-19
Determining the Primary RP 7-19
Role of the Standby RP 7-20
Summary of Redundancy Commands 7-20
Automatic Failover 7-20
RP Redundancy During RP Reset 7-20
Manual Failover 7-21
Communicating with a Standby RP 7-22
Reloading, Shutting Down, or Power Cycling a Node 7-22
Reloading the Primary RP 7-23
Administratively Shutting Down or Powering On or Off a Node 7-24
Using Controller Commands to Manage Hardware Components 7-24
Formatting Hard Drives, Flash Drives, and Other Storage Devices 7-25
CHAPTER 8 Online Insertion and Removal for Switch Fabric Cards 8-1
Contents 8-1
Information About OIR 8-1
Performing an OIR 8-1

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English