Cisco CRS-1 - Carrier Routing System Router Getting Started Guide

4-11
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
Chapter 4 Bringing up a New Cisco CRS-1 Router
Bringing Up a Single-Chassis System for the First Time
In the following example, temperature information for the router is shown:
RP/0/RP0/CPU0:router# show environment temperatures
R/S/I Modules Inlet Exhaust Hotspot
Temperature Temperature Temperature
(deg C) (deg C) (deg C)
0/2/* host 31, 27 43, 45 48
cpu 31
fabricq0 46
fabricq1 44
ingressq 34
egressq 41 43
ingresspse 35
egresspse 42
plimasic 30, 31 42
0/RP1/* host 38 44
cpu 36
ingressq 42
fabricq0 43
0/SM0/* host 29, 29 41, 33
In the following example, LED status of the nodes in the router is shown:
RP/0/RP0/CPU0:router# show environment leds
0/2/*: Module (host) LED status says: OK
0/2/*: Module (plimasic) LED status says: OK
0/SM0/*: Module (host) LED status says: OK
Refer to the “Hardware Redundancy and Node Administration Commands on Cisco IOS XR Software”
section in the Cisco IOS XR Interface and Hardware Component Command Reference for more
information.
show platform Command
The following is sample output from the show platform command for all nodes in a router:
RP/0/RP0/CPU0:router# show platform
Node Type PLIM State Config State
-----------------------------------------------------------------------------
0/0/SP MSC(SP) N/A IOS-XR RUN PWR,NSHUT,MON
0/0/CPU0 MSC 16OC48-POS/DPT IOS-XR RUN PWR,NSHUT,MON
0/2/SP MSC(SP) N/A IOS-XR RUN PWR,NSHUT,MON
0/2/CPU0 MSC 16OC48-POS/DPT IOS-XR RUN PWR,NSHUT,MON
0/RP0/CPU0 RP(Standby) N/A IOS-XR RUN PWR,NSHUT,MON
0/RP1/CPU0 RP(Active) N/A IOS-XR RUN PWR,NSHUT,MON
0/SM0/SP FC/S(SP) N/A IOS-XR RUN PWR,NSHUT,MON
In the following example, information is shown for a single node in the system:
RP/0/RP0/CPU0:router# show platform 0/2/cpu0
Node Type PLIM State Config State
-----------------------------------------------------------------------------
0/2/CPU0 MSC 16OC48-POS/DPT IOS-XR RUN PWR,NSHUT,MON
For more information on nodeID, see the “Command Syntax for Hardware Nodes (location nodeID)”
section on page 7-4.

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English