EasyManuals Logo

Cisco ME 3400 User Manual

Cisco ME 3400
1138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1015 background imageLoading...
Page #1015 background image
44-3
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 44 Troubleshooting
Recovering from a Lost or Forgotten Password
Step 6 Press the break key, and at the same time, reconnect the power cord to the switch.
You can release the break key a second or two after the LED above port 1 goes off. Several lines of
information about the software appear along with instructions:
The system has been interrupted, or encountered an error during initialization of the
flash filesystem. The following commands will initialize the flash filesystem, and finish
loading the operating system software:
flash_init
load_helper
boot
Step 7 Initialize the flash file system:
switch: flash_init
Step 8 If you had set the console port speed to anything other than 9600, it has been reset to that particular
speed. Change the emulation software line speed to match that of the switch console port.
Step 9 Load any helper files:
switch: load_helper
Step 10 Start the file transfer by using the Xmodem Protocol.
switch: copy xmodem: flash:image_filename.bin
Step 11 After the Xmodem request appears, use the appropriate command on the terminal-emulation software to
start the transfer and to copy the software image into flash memory.
Step 12 Boot the newly downloaded Cisco IOS image.
switch:boot flash:image_filename.bin
Step 13 Use the archive download-sw privileged EXEC command to download the software image to the
switch.
Step 14 Use the reload privileged EXEC command to restart the switch and to verify that the new software image
is operating properly.
Step 15 Delete the flash:image_filename.bin file from the switch.
Recovering from a Lost or Forgotten Password
The default configuration for the switch allows an end user to recover from a lost password by
interrupting the boot process during power-on and by entering a new password.
Note On these switches, a system administrator can disable some of the functionality of password recovery
by allowing an end user to reset a password only by agreeing to return to the default configuration. If
you are an end user trying to reset a password when password recovery has been disabled, a status
message shows this during the recovery process.
Disabling password recovery provides configuration file security by preventing unauthorized users from
accessing the configuration file.

Table of Contents

Other manuals for Cisco ME 3400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ME 3400 and is the answer not in the manual?

Cisco ME 3400 Specifications

General IconGeneral
CategorySwitch
Rack MountableYes
Jumbo Frame SupportYes
Authentication MethodRADIUS, TACACS+
RAM128 MB
Flash Memory32 MB
Power DeviceInternal power supply
ModelME 3400
LayerLayer 2
MAC Address Table Size8000 entries
Remote Management ProtocolSNMP, Telnet, SSH, HTTP, HTTPS
FeaturesVLAN support, IGMP snooping, Quality of Service (QoS)
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.3x
Memory128 MB
Power SupplyAC 120/230 V (50/60 Hz)
Dimensions (H x W x D)4.4 cm x 44.5 cm x 24.2 cm
Routing ProtocolStatic routing

Related product manuals