Cisco ME 3400 User Manual

8-24
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 8 Configuring IEEE 802.1x Port-Based Authentication
Displaying IEEE 802.1x Statistics and Status
This example shows how to configure a switch as a supplicant:
Switch# configure terminal
Switch(config)# cisp enable
Switch(config)# dot1x credentials test
Switch(config)# username suppswitch
Switch(config)# password myswitch
Switch(config)# interface gigabitethernet 0/1
Switch(config-if)# switchport trunk encapsulation dot1q
Switch(config-if)# dot1x pae supplicant
Switch(config-if)# dot1x credentials test
Switch(config-if)# end
Displaying IEEE 802.1x Statistics and Status
To display IEEE 802.1x statistics for all ports, use the show dot1x all statistics privileged EXEC
command. To display IEEE 802.1x statistics for a specific port, use the show dot1x statistics interface
interface-id privileged EXEC command.
To display the IEEE 802.1x administrative and operational status for the switch, use the show dot1x all
privileged EXEC command. To display the IEEE 802.1x administrative and operational status for a
specific port, use the show dot1x interface interface-id privileged EXEC command.
For detailed information about the fields in these displays, see the command reference for this release.
Step 12
show running-config interface
interface-id
Verify your configuration.
Step 13
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose

Cisco ME 3400 Specifications

General

Category	Switch
Rack Mountable	Yes
Jumbo Frame Support	Yes
Authentication Method	RADIUS, TACACS+
RAM	128 MB
Flash Memory	32 MB
Power Device	Internal power supply
Model	ME 3400
Layer	Layer 2
MAC Address Table Size	8000 entries
Remote Management Protocol	SNMP, Telnet, SSH, HTTP, HTTPS
Features	VLAN support, IGMP snooping, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.3x
Memory	128 MB
Power Supply	AC 120/230 V (50/60 Hz)
Dimensions (H x W x D)	4.4 cm x 44.5 cm x 24.2 cm
Routing Protocol	Static routing