Cisco ME 3400 - APPENDIX C Unsupported Commands in Cisco IOS Release 12.2(50)SE; Access Control Lists; ARP Commands; Unsupported Global Configuration Commands

C-1
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
APPENDIX
C
Unsupported Commands in
Cisco IOS Release 12.2(50)SE
This appendix lists some of the command-line interface (CLI) commands that appear when you enter the
question mark (?) at the Cisco Metro Ethernet (ME) 3400 Ethernet Access switch prompt but are not
supported in this release, either because they are not tested or because of switch hardware limitations.
This is not a complete list. The unsupported commands are listed by software feature and command
mode.
Access Control Lists
Unsupported Privileged EXEC Commands
access-enable [host] [timeout minutes]
access-template [access-list-number | name] [dynamic-name] [source] [destination] [timeout minutes]
clear access-template [access-list-number | name] [dynamic-name] [source] [destination].
Unsupported Global Configuration Commands
access-list rate-limit acl-index {precedence | mask prec-mask}
access-list dynamic extended
ARP Commands
Unsupported Global Configuration Commands
arp ip-address hardware-address smds
arp ip-address hardware-address srp-a
arp ip-address hardware-address srp-b