C-5
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Appendix C Unsupported Commands in Cisco IOS Release 12.2(50)SE
Interface Commands
Interface Commands
Unsupported Privileged EXEC Commands
show interfaces [interface-id | vlan vlan-id] [crb | fair-queue | irb | mac-accounting | precedence | irb
| random-detect | rate-limit | shape]
Unsupported Global Configuration Commands
interface tunnel
Unsupported Interface Configuration Commands
transmit-interface type number
IP Multicast Routing
Unsupported Privileged EXEC Commands
clear ip rtp header-compression [type number]
clear ip dvmrp route commands
debug ip dvmrp commands
The debug ip packet command displays packets received by the switch CPU. It does not display packets
that are hardware-switched.
The debug ip mcache command affects packets received by the switch CPU. It does not display packets
that are hardware-switched.
The debug ip mpacket [detail] [access-list-number [group-name-or-address] command affects only
packets received by the switch CPU. Because most multicast packets are hardware-switched, use this
command only when you know that the route will forward the packet to the CPU.
debug ip pim atm
show frame-relay ip rtp header-compression [interface type number]
show ip dvmrp route commands
The show ip mcache command displays entries in the cache for those packets that are sent to the switch
CPU. Because most multicast packets are switched in hardware without CPU involvement, you can use
this command, but multicast packet information is not displayed.
The show ip mpacket commands are supported but are only useful for packets received at the switch
CPU. If the route is hardware-switched, the command has no effect because the CPU does not receive
the packet and cannot display it.
show ip pim vc [group-address | name] [type number]
show ip rtp header-compression [type number] [detail]
To Next Page
Loading...
Need help?
General
