Cisco ME 3400 User Manual

18-7
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 18 Configuring Flex Links and the MAC Address-Table Move Update Feature
Configuring Flex Links and MAC Address-Table Move Update
Figure 18-3 MAC Address-Table Move Update Example
Configuring Flex Links and MAC Address-Table Move Update
• Default Configuration, page 18-7
• Configuration Guidelines, page 18-8
• Configuring Flex Links, page 18-8
• Configuring VLAN Load Balancing on Flex Links, page 18-10
• Configuring the MAC Address-Table Move Update Feature, page 18-12
Default Configuration
The Flex Links are not configured, and there are no backup interfaces defined.
The preemption mode is off.
The preemption delay is 35 seconds.
Flex Link VLAN load-balancing is not configured.
The MAC address-table move update feature is not configured on the switch.
Switch C
Port 3
Port 1
Port 2
Port 4
Switch A
Switch B Switch D
Server
PC
141223

Cisco ME 3400 Specifications

General

Category	Switch
Rack Mountable	Yes
Jumbo Frame Support	Yes
Authentication Method	RADIUS, TACACS+
RAM	128 MB
Flash Memory	32 MB
Power Device	Internal power supply
Model	ME 3400
Layer	Layer 2
MAC Address Table Size	8000 entries
Remote Management Protocol	SNMP, Telnet, SSH, HTTP, HTTPS
Features	VLAN support, IGMP snooping, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.3x
Memory	128 MB
Power Supply	AC 120/230 V (50/60 Hz)
Dimensions (H x W x D)	4.4 cm x 44.5 cm x 24.2 cm
Routing Protocol	Static routing