Cisco ME 3400 User Manual

CHAPTER
9-1
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
9
Configuring Interfaces
This chapter defines the types of interfaces on the Cisco ME 3400 Ethernet Access switch and describes
how to configure them.
• Understanding Interface Types, page 9-1
• Using Interface Configuration Mode, page 9-8
• Configuring Ethernet Interfaces, page 9-12
• Configuring Layer 3 Interfaces, page 9-22
• Configuring the System MTU, page 9-24
• Monitoring and Maintaining the Interfaces, page 9-26
Note For complete syntax and usage information for the commands used in this chapter, see the switch
command reference for this release and the online Cisco IOS Interface Command Reference,
Release 12.2.
Understanding Interface Types
This section describes the different types of interfaces supported by the switch with references to
chapters that contain more detailed information about configuring these interface types. The rest of the
chapter describes configuration procedures for physical interface characteristics.
• UNI, NNI, and ENI Port Types, page 9-2
• Port-Based VLANs, page 9-2
• Switch Ports, page 9-3
• Routed Ports, page 9-5
• Switch Virtual Interfaces, page 9-5
• EtherChannel Port Groups, page 9-6
• Dual-Purpose Ports, page 9-6
• Connecting Interfaces, page 9-7

Cisco ME 3400 Specifications

General

Category	Switch
Rack Mountable	Yes
Jumbo Frame Support	Yes
Authentication Method	RADIUS, TACACS+
RAM	128 MB
Flash Memory	32 MB
Power Device	Internal power supply
Model	ME 3400
Layer	Layer 2
MAC Address Table Size	8000 entries
Remote Management Protocol	SNMP, Telnet, SSH, HTTP, HTTPS
Features	VLAN support, IGMP snooping, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.3x
Memory	128 MB
Power Supply	AC 120/230 V (50/60 Hz)
Dimensions (H x W x D)	4.4 cm x 44.5 cm x 24.2 cm
Routing Protocol	Static routing