Cisco ME 3400 User Manual

CHAPTER
37-1
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
37
Configuring IPv6 ACLs
When the Cisco ME 3400 Ethernet Access switch is running the metro IP access image, you can filter
IP Version
6 (IPv6) traffic by creating IPv6 access control lists (ACLs) and applying them to interfaces
similarly to the way that you create and apply IP Version 4 (IPv4) named ACLs. You can also create and
apply input router ACLs to filter Layer 3 management traffic.
Note To use IPv6, you must configure the dual IPv4 and IPv6 Switch Database Management (SDM) template
on the switch. You select the template by entering the sdm prefer dual-ipv4-and-ipv6 {default |
routing | vlan} global configuration command.
For related information, see these chapters:
• For more information about SDM templates, see Chapter 6, “Configuring SDM Templates.”
• For information about IPv6 on the switch, seeChapter 36, “Configuring IPv6 Unicast Routing.”
• For information about ACLs on the switch, see Chapter 31, “Configuring Network Security with
ACLs.”
Note For complete syntax and usage information for the commands used in this chapter, see the command
reference for this release or the Cisco IOS documentation referenced in the procedures.
This chapter contains these sections:
• Understanding IPv6 ACLs, page 37-2
• Configuring IPv6 ACLs, page 37-3
• Displaying IPv6 ACLs, page 37-8

Cisco ME 3400 Specifications

General

Category	Switch
Rack Mountable	Yes
Jumbo Frame Support	Yes
Authentication Method	RADIUS, TACACS+
RAM	128 MB
Flash Memory	32 MB
Power Device	Internal power supply
Model	ME 3400
Layer	Layer 2
MAC Address Table Size	8000 entries
Remote Management Protocol	SNMP, Telnet, SSH, HTTP, HTTPS
Features	VLAN support, IGMP snooping, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.3x
Memory	128 MB
Power Supply	AC 120/230 V (50/60 Hz)
Dimensions (H x W x D)	4.4 cm x 44.5 cm x 24.2 cm
Routing Protocol	Static routing