EasyManuals Logo

Cisco ME 3400 User Manual

Cisco ME 3400
1138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #770 background imageLoading...
Page #770 background image
35-44
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 35 Configuring IP Unicast Routing
Configuring BGP
For detailed descriptions of BGP configuration, see the “Configuring BGP” chapter in the “IP Routing
Protocols” part of the Cisco IOS IP Configuration Guide, Release 12.2. For details about specific
commands, see the Cisco IOS IP Command Reference, Volume 2 of 3: Routing Protocols, Release
12.2.For a list of BGP commands that are visible but not supported by the switch, see
Appendix C,
“Unsupported Commands in Cisco IOS Release 12.2(50)SE.
Default BGP Configuration
Ta b l e 35-9 Default BGP Configuration
Feature Default Setting
Aggregate address Disabled: None defined.
AS path access list None defined.
Auto summary Enabled.
Best path The router considers as-path in choosing a route and does not compare similar
routes from external BGP peers.
Compare router ID: Disabled.
BGP community list Number: None defined. When you permit a value for the community number, the
list defaults to an implicit deny for everything else that has not been permitted.
Format: Cisco default format (32-bit number).
BGP confederation identifier/peers Identifier: None configured.
Peers: None identified.
BGP Fast external fallover Enabled.
BGP local preference 100. The range is 0 to 4294967295 with the higher value preferred.
BGP network None specified; no backdoor route advertised.
BGP route dampening Disabled by default. When enabled:
Half-life is 15 minutes.
Re-use is 750 (10-second increments).
Suppress is 2000 (10-second increments).
Max-suppress-time is 4 times half-life; 60 minutes.
BGP router ID The IP address of a loopback interface if one is configured or the highest IP address
configured for a physical interface on the router.
Default information originate
(protocol or network redistribution)
Disabled.
Default metric Built-in, automatic metric translations.
Distance External route administrative distance: 20 (acceptable values are from 1 to 255).
Internal route administrative distance: 200 (acceptable values are from 1 to 255).
Local route administrative distance: 200 (acceptable values are from 1 to 255).
Distribute list In (filter networks received in updates): Disabled.
Out (suppress networks from being advertised in updates): Disabled.
Internal route redistribution Disabled.

Table of Contents

Other manuals for Cisco ME 3400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ME 3400 and is the answer not in the manual?

Cisco ME 3400 Specifications

General IconGeneral
CategorySwitch
Rack MountableYes
Jumbo Frame SupportYes
Authentication MethodRADIUS, TACACS+
RAM128 MB
Flash Memory32 MB
Power DeviceInternal power supply
ModelME 3400
LayerLayer 2
MAC Address Table Size8000 entries
Remote Management ProtocolSNMP, Telnet, SSH, HTTP, HTTPS
FeaturesVLAN support, IGMP snooping, Quality of Service (QoS)
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.3x
Memory128 MB
Power SupplyAC 120/230 V (50/60 Hz)
Dimensions (H x W x D)4.4 cm x 44.5 cm x 24.2 cm
Routing ProtocolStatic routing

Related product manuals