21-28
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 21 Configuring IGMP Snooping and MVR
Displaying IGMP Filtering and Throttling Configuration
To prevent the switch from removing the forwarding-table entries, you can configure the IGMP
throttling action before an interface adds entries to the forwarding table.
Beginning in privileged EXEC mode, follow these steps to configure the throttling action when the
maximum number of entries is in the forwarding table:
To return to the default action of dropping the report, use the no ip igmp max-groups action interface
configuration command.
This example shows how to configure a port to remove a randomly selected multicast entry in the
forwarding table and to add an IGMP group to the forwarding table when the maximum number of
entries is in the table.
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# ip igmp max-groups action replace
Switch(config-if)# end
Displaying IGMP Filtering and Throttling Configuration
You can display IGMP profile characteristics, and you can display the IGMP profile and maximum group
configuration for all interfaces on the switch or for a specified interface. You can also display the IGMP
throttling configuration for all interfaces on the switch or for a specified interface.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface-id Specify the physical interface to be configured, and enter interface
configuration mode. The interface can be a Layer 2 port that does not
belong to an EtherChannel group or an EtherChannel interface. The
interface cannot be a trunk port.
Step 3
no shutdown Enable the port, if necessary. By default, UNIs and ENIs are disabled,
and NNIs are enabled.
Step 4
ip igmp max-groups action {deny |
replace}
When an interface receives an IGMP report and the maximum number
of entries is in the forwarding table, specify the action that the interface
takes:
• deny—Drop the report.
• replace—Replace the existing group with the new group for which
the IGMP report was received.
Step 5
end Return to privileged EXEC mode.
Step 6
show running-config interface
interface-id
Verify the configuration.
Step 7
copy running-config startup-config (Optional) Save your entries in the configuration file.
To Next Page
Loading...
Need help?
General
