19-7
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 19 Configuring DHCP Features and IP Source Guard
Configuring DHCP Features
When a switch learns of new bindings or when it loses bindings, the switch immediately updates the
entries in the database. The switch also updates the entries in the binding file. The frequency at which
the file is updated is based on a configurable delay, and the updates are batched. If the file is not updated
in a specified time (set by the write-delay and abort-timeout values), the update stops.
This is the format of the file that has the bindings:
<initial-checksum>
TYPE DHCP-SNOOPING
VERSION 1
BEGIN
<entry-1> <checksum-1>
<entry-2> <checksum-1-2>
...
...
<entry-n> <checksum-1-2-..-n>
END
Each entry in the file is tagged with a checksum value that the switch uses to verify the entries when it
reads the file. The initial-checksum entry on the first line distinguishes entries associated with the latest
file update from entries associated with a previous file update.
This is an example of a binding file:
2bb4c2a1
TYPE DHCP-SNOOPING
VERSION 1
BEGIN
192.1.168.1 3 0003.47d8.c91f 2BB6488E Fa1/0/4 21ae5fbb
192.1.168.3 3 0003.44d6.c52f 2BB648EB Fa1/0/4 1bdb223f
192.1.168.2 3 0003.47d9.c8f1 2BB648AB Fa1/0/4 584a38f0
END
When the switch starts and the calculated checksum value equals the stored checksum value, the switch
reads entries from the binding file and adds the bindings to its DHCP snooping binding database. The
switch ignores an entry when one of these situations occurs:
• The switch reads the entry and the calculated checksum value does not equal the stored checksum
value. The entry and the ones following it are ignored.
• An entry has an expired lease time (the switch might not remove a binding entry when the lease time
expires).
• The interface in the entry no longer exists on the system.
• The interface is a routed interface or a DHCP snooping-trusted interface.
Configuring DHCP Features
• Default DHCP Configuration, page 19-8
• DHCP Snooping Configuration Guidelines, page 19-8
• Configuring the DHCP Server, page 19-10
• Configuring the DHCP Relay Agent, page 19-10
• Specifying the Packet Forwarding Address, page 19-10
• Enabling DHCP Snooping and Option 82, page 19-11
• Enabling DHCP Snooping on Private VLANs, page 19-13
To Next Page
Loading...
Need help?
General
