CHAPTER
38-1
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
38
Configuring HSRP
This chapter describes how to use Hot Standby Router Protocol (HSRP) on the Cisco ME3400 Ethernet
Access switch to provide routing redundancy for routing IP traffic without being dependent on the
availability of any single router. The switch must be running the metro IP access image to support HSRP.
Note For complete syntax and usage information for the commands used in this chapter, see the switch
command reference for this release and the Cisco IOS IP Command Reference, Volume 1 of 3:
Addressing and Services, Release 12.2.
• Understanding HSRP, page 38-1
• Configuring HSRP, page 38-5
• Displaying HSRP Configurations, page 38-12
Understanding HSRP
HSRP is Cisco’s standard method of providing high network availability by providing first-hop
redundancy for IP hosts on an IEEE 802 LAN configured with a default gateway IP address. HSRP routes
IP traffic without relying on the availability of any single router. It enables a set of router interfaces to
work together to present the appearance of a single virtual router or default gateway to the hosts on a
LAN. When HSRP is configured on a network or segment, it provides a virtual Media Access Control
(MAC) address and an IP address that is shared among a group of configured routers. HSRP allows two
or more HSRP-configured routers to use the MAC address and IP network address of a virtual router.
The virtual router does not exist; it represents the common target for routers that are configured to
provide backup to each other. One of the routers is selected to be the active router and another to be the
standby router, which assumes control of the group MAC address and IP address should the designated
active router fail.
Note Routers in an HSRP group can be any router interface that supports HSRP, including routed ports and
switch virtual interfaces (SVIs) on the switch.
To Next Page
Loading...
Need help?
General
