29-10
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 29 Configuring SNMP
Configuring SNMP
This example shows how to assign the string comaccess to SNMP, to allow read-only access, and to
specify that IP access list 4 can use the community string to gain access to the switch SNMP agent:
Switch(config)# snmp-server community comaccess ro 4
Configuring SNMP Groups and Users
You can specify an identification name (engine ID) for the local or remote SNMP server engine on the
switch. You can configure an SNMP server group that maps SNMP users to SNMP views, and you can
add new users to the SNMP group.
Beginning in privileged EXEC mode, follow these steps to configure SNMP on the switch:
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
snmp-server engineID {local
engineid-string | remote ip-address
[udp-port port-number] engineid-string}
Configure a name for either the local or remote copy of SNMP.
• The engineid-string is a 24-character ID string with the name of
the copy of SNMP. You need not specify the entire 24-character
engine ID if it has trailing zeros. Specify only the portion of the
engine ID up to the point where only zeros remain in the value.
For example, to configure an engine ID of
123400000000000000000000, you can enter this: snmp-server
engineID local 1234
• If you select remote, specify the ip-address of the device that
contains the remote copy of SNMP and the optional User
Datagram Protocol (UDP) port to use for storing data on the
remote device. The default is 162.
To Next Page
Loading...
Need help?
General
