Cisco ME 3400 - Page 1131

Index
IN-45
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Switched Port Analyzer
See SPAN
switched ports 9-3
switchport backup interface 18-4, 18-5
switchport block multicast command 22-8
switchport block unicast command 22-8
switchport command 9-12
switchport mode dot1q-tunnel command 13-6
switchport protected command 22-7
switch priority
MSTP 15-22
STP 14-20
switch software features 1-1
switch virtual interface
See SVI
synchronization, BGP 35-46
syslog
See system message logging
system clock
configuring
daylight saving time 5-13
manually 5-11
summer time 5-13
time zones 5-12
displaying the time and date 5-12
overview 5-2
See also NTP
system message logging
default configuration 28-3
defining error message severity levels 28-8
disabling 28-4
displaying the configuration 28-13
enabling 28-4
facility keywords, described 28-13
level keywords, described 28-9
limiting messages 28-10
message format 28-2
overview 28-1
sequence numbers, enabling and disabling 28-8
system message logging (continued)
setting the display destination device 28-5
synchronizing log messages 28-6
syslog facility 1-10
time stamps, enabling and disabling 28-7
UNIX syslog servers
configuring the daemon 28-12
configuring the logging facility 28-12
facilities supported 28-13
system MTU
and IEEE 802.1Q tunneling 13-5
and IS-IS LSPs 35-67
system name
default configuration 5-15
default setting 5-15
manual configuration 5-15
See also DNS
system prompt, default setting 5-15
system resources, optimizing 6-1
system routing
IS-IS 35-62
ISO IGRP 35-62
System-to-Intermediate System Protocol
See IS-IS
T
table maps
default actions 33-13
described 33-13
for QoS marking 33-19
QoS, configuring 33-37
types of 33-14
TACACS+
accounting, defined 7-11
authentication, defined 7-11
authorization, defined 7-11