6-6
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 6 Configuring SDM Templates
Displaying the SDM Templates
This is an example of output from the show sdm prefer layer-2 command:
Switch# show sdm prefer layer-2
"layer-2" template:
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses: 8K
number of IPv4 IGMP groups: 1K
number of IPv4 multicast routes: 0
number of IPv4 unicast routes: 0
number of IPv4 policy based routing aces: 0
number of IPv4/MAC qos aces: 0.5K
number of IPv4/MAC security aces: 1K
This is an example of output from the show sdm prefer dual-ipv4-and-ipv6 routing command:
Switch# show sdm prefer dual-ipv4-and-ipv6 routing
"desktop IPv4 and IPv6 routing" template:
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses: 1.5K
number of IPv4 IGMP groups + multicast routes: 1K
number of IPv4 unicast routes: 2.75K
number of directly-connected IPv4 hosts: 1.5K
number of indirect IPv4 routes: 1.25K
number of IPv6 multicast groups: 1.125k
number of directly-connected IPv6 addresses: 1.5K
number of indirect IPv6 unicast routes: 1.25K
number of IPv4 policy based routing aces: 0.25K
number of IPv4/MAC qos aces: 0.75K
number of IPv4/MAC security aces: 0.5K
number of IPv6 policy based routing aces: 0.25K
number of IPv6 qos aces: 0.5K
number of IPv6 security aces: 0.5K
To Next Page
Loading...
