Cisco ME 3400 - Page 698

33-72
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 33 Configuring QoS
Configuration Examples for Policy Maps
This is the overall sequence of configuration:
• Shut down all active ports.
• Detach the output policies from all Fast Ethernet and Gigabit Ethernet ports.
• Delete the class.
• Reattach the output policies to the Fast Ethernet and Gigabit Ethernet ports.
• Take the Fast Ethernet and Gigabit Ethernet ports out of the shutdown state.
These steps shut down all active and applicable Fast Ethernet and Gigabit Ethernet ports:
Switch(config)# interface range gigabitethernet0/1-2, fastethernet0/1-12
Switch(config-if-range)# shutdown
Switch(config-if-range)# exit
These steps detach all output policies from the affected Fast Ethernet and Gigabit Ethernet ports:
Switch(config)# interface range fastethernet0/1-8
Switch(config-if-range)# no service-policy output output1-8
Switch(config-if-range)# exit
Switch(config)# interface range fastethernet0/9-12
Switch(config-if-range)# no service-policy output output9-12
Switch(config-if-range)# exit
Switch(config)# interface range gigabitethernet0/1-2
Switch(config-if-range)# no service-policy output output-g1-2
Switch(config-if-range)# exit
These steps delete a class from all output policy maps and input policy maps; the input policy can be left
attached or can be detached:
Switch(config)# policy-map output1-8
Switch(config-pmap)# no class bronze-out
Switch(config-pmap-c)# exit
Switch(config)# policy-map output9-12
Switch(config-pmap)# no class bronze-out
Switch(config-pmap-c)# exit
Switch(config)# policy-map output-g1-2
Switch(config-pmap)# no class bronze-out
Switch(config-pmap-c)# exit
Switch(config)# policy-map input-all
Switch(config-pmap)# no class bronze-in
Switch(config-pmap-c)# exit
These steps reattach all policies to the Fast Ethernet and Gigabit Ethernet ports:
Switch(config)# interface range fastethernet0/1-8
Switch(config-if-range)# service-policy output output1-8
Switch(config-if-range)# exit
Switch(config)# interface range fastethernet0/9-12
Switch(config-if-range)# service-policy output output9-12
Switch(config-if-range)# exit
Switch(config)# interface range gigabitethernet0/1-2
Switch(config-if-range)# service-policy output output9-12
Switch(config-if-range)# exit