Cisco Nexus 3548

127
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
feature hsrp
feature hsrp
To enter Hot Standby Router Protocol (HSRP) configuration mode and enable HSRP, use the feature
hsrp command. To disable HSRP, use the no form of this command.
feature hsrp
no feature hsrp
Syntax Description The command has no arguments or keywords.
Command Default Disabled
Command Modes Global configuration mode
Command History
Usage Guidelines You must enable the HSRP feature before you can configure HSRP.
This command does not require a license.
Examples This example shows how to enable HSRP on the switch:
switch# configure terminal
switch(config)# feature hsrp
switch(config)#
This example shows how to disable HSRP:
switch# configure terminal
switch(config)# no feature hsrp
switch(config)#
Related Commands
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
hsrp group Creates and activates an HSRP group.
show feature Displays the status of features on a switch.
show hsrp Displays HSRP information.