Cisco Nexus 3548

498
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Show Commands
show ip rip
show ip rip
To display the configuration and status of the Routing Information Protocol (RIP), use the show ip rip
command in any mode.
show ip rip [instance-tag] [vrf vrf-name]
Syntax Description
Command Default No default behavior or values
Command Modes Any command mode
Command History
Examples This example shows how to display the RIP configuration information:
switch(config-if)# show ip rip
Related Commands
instance-tag (Optional) RIP instance. The instance tag can be a maximum of 20
alphanumeric characters.
vrf vrf-name (Optional) Specifies the name of the virtual routing and forwarding (VRF)
instance. The vrf-name argument can be specified as any case-sensitive,
alphanumeric string up to 32 characters. The strings “default” and “all” are
reserved VRF names.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
show ip rip interface Displays RIP information for an interface.
show ip rip neighbor Displays RIP neighbor information.
show ip rip policy statistics Displays RIP policy statistics.
show ip rip route Displays RIP route information.
show ip rip statistics Displays RIP statistics.