Cisco Nexus 3548

489
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Show Commands
show ip ospf request-list
show ip ospf request-list
To display a list of all link-state advertisements (LSAs) requested by a router, use the show ip ospf
request-list command.
show ip ospf request-list neighbor-id {ethernet slot/port | loopback if_number | port-channel
number}
Syntax Description
Command Default None
Command Modes Any command mode
Command History
Usage Guidelines Use the show ip ospf request-list command to troubleshoot Open Shortest Path First (OSPF) routing
operations.
This command requires the LAN Enterprise Services license.
Examples This example shows how to display a list of all LSAs requested by a router:
switch# show ip ospf request-list 40.40.40 ethernet 2/1
Related Commands
neighbor-id Router ID of the neighbor. Specify as an IP address.
ethernet slot/port (Optional) Specifies the Ethernet interface and the slot number and port
number. The slot number is from 1 to 255, and the port number is from 1 to
128.
loopback if_number (Optional) Specifies the loopback interface. The loopback interface number is
from 0 to 1023.
port-channel number (Optional) Specifies the EtherChannel interface and EtherChannel number.
The range is from 1 to 4096.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
show running-config
ospf
Displays the OSPF running configuration.